Jeep Cherokee

 Owners Manual

Starting and operating » Four-wheel drive operation
2-Speed Four-Wheel Drive (4X4) - If Equipped

2-Speed 4x4 Switch

2-Speed 4x4 Switch (with Rear Lock)

The Four-Wheel Drive is fully automatic in the normal driving mode. The Selec-Terrain buttons provide three selectable mode positions:

• 4WD LOW
• REAR LOCK (If Equipped)
• NEUTRAL

When additional traction is required, the 4WD LOW range position can be used to provide an additional gear reduction which allows for increased torque to be delivered to both the front and rear wheels. 4WD LOW is intended for loose, slippery road surfaces only. Driving in 4WD LOW on dry, hard-surfaced roads may cause increased tire wear and damage to driveline components.

When operating your vehicle in 4WD LOW, the engine speed is approximately three times that of the normal driving mode at a given road speed. Take care not to overspeed the engine and do not exceed 25 mph (40 km/h).

Proper operation of four-wheel drive vehicles depends on tires of equal size, type, and circumference on each wheel. Any difference will adversely affect shifting and cause damage to the driveline components.

Because four-wheel drive provides improved traction, there is a tendency to exceed safe turning and stopping speeds. Do not go faster than road conditions permit.

1-Speed Four-Wheel Drive (4X4) - If Equipped

2-Speed Four-Wheel Drive (4X4) - If Equipped

Shift Positions

Shifting Procedures

Rear Electronic Locker (E-Locker) System - If Equipped