Toyota
Jeep Cherokee
 Service Manual
Differential and driveline » 8 1/4 Rear axle » Removal and installation
Axle seal and bearing

REMOVAL

(1) Remove axle shaft.

(2) Remove axle shaft seal from the end of the axle tube with a small pry bar (Fig. 10).

NOTE: The seal and bearing can be removed at the same time with the bearing removal tool.

(3) Remove the axle shaft bearing from the axle tube with Bearing Removal Tool Set 6310, using Adapter Foot 6310-9 (Fig. 11).

INSTALLATION

NOTE: Do not install the original axle shaft seal.

Always install a new seal.

(1) Wipe the axle tube bore clean. Remove any old sealer or burrs from the tube.

Fig. 10 Axle Seal Removal
Fig. 10 Axle Seal Removal

1 - AXLE TUBE
2 - AXLE SEAL
3 - PRY BAR

Fig. 11 Axle Shaft Bearing Removal Tool
Fig. 11 Axle Shaft Bearing Removal Tool

1 - NUT
2 - GUIDE PLATE
3 - GUIDE
4 - THREADED ROD
5 - ADAPTER
6 - FOOT
7 - AXLE TUBE

(2) Install the axle shaft bearing with Installer C-4198 and Handle C-4171 (Fig. 12). Ensure that the bearing part number is against the installer. Verify that the bearing in installed straight and the tool fully contacts the axle tube when seating the bearing.

(3) Install a new axle seal with Installer C-4076-B and Handle C-4735-1. When the tool contacts the axle tube, the seal is installed to the correct depth.

(4) Coat the lip of the seal with axle lubricant for protection prior to installing the axle shaft.

(5) Install the axle shaft.

Fig. 12 Axle Shaft Seal and Bearing Installation
Fig. 12 Axle Shaft Seal and Bearing Installation

1 - HANDLE
2 - INSTALLER
3 - AXLE TUBE

    More about «Removal and installation»:

    Rear axle

    Axle shaft

    Axle seal and bearing

    Pinion seal

    Differential

    Differential side bearings

    Ring gear

    Pinion gear

    Jeep Cherokee Service Manual / Differential and driveline / 8 1/4 Rear axle / Removal and installation / Axle seal and bearing

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com