Jeep Cherokee

 Owners Manual

Maintaining your vehicle » Bulb replacement » Low Beam And High Beam Headlamps
Bi-Halogen Headlamps

1. Remove the 3 hex head screws from the wheel liner.

2. Pull the exterior edge of the liner towards the tire to gain access to the headlamp bulb cap.

3. Firmly grasp the cap and rotate it counterclockwise to unlock it.

4. Firmly grasp the bulb and connector assembly and rotate counterclockwise to remove from the housing.

5. Disconnect the bulb from the electrical connector and then connect the replacement bulb.

CAUTION!

Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life. If the bulb comes in contact with any oily surface, clean the bulb with rubbing alcohol.

6. Install the bulb and connector assembly into the headlamp housing and rotate clockwise to lock it in place.

7. Install the bulb cap in the headlamp housing and rotate clockwise to lock it in place.

8. Install the 3 hex head screws into the wheel liner.

Bi-Xenon High Intensity Discharge (HID) Headlamps - If Equipped

Bi-Halogen Headlamps