Toyota
Jeep Cherokee
 Service Manual
Brakes » Base brake system » Diagnosis and testing
Brake lamp switch

The brake lamp switch operation can be tested with an ohmmeter. The ohmmeter is used to check continuity between the pin terminals (Fig. 6).

SWITCH CIRCUIT IDENTIFICATION

  •  Terminals 1 and 2: brake sensor circuit
  •  Terminals 3 and 4: speed control circuit if equipped
  •  Terminals 5 and 6: brake lamp circuit

Fig. 6 Brake Lamp Switch Terminal Identification
Fig. 6 Brake Lamp Switch Terminal Identification

1 - TERMINAL PINS
2 - PLUNGER TEST POSITIONS

SWITCH CONTINUITY TEST

NOTE: Disconnect switch harness before testing switch continuity.

With the switch plunger retracted, attach test leads to terminal pins 1 and 2. Replace switch if meter indicates no continuity.

With the switch plunger retracted, attach test leads to terminal pins 3 and 4. Replace switch if meter indicates no continuity.

With the switch plunger extended, attach test leads to terminal pins 5 and 6. Replace switch if meter indicates no continuity.

    More about «Diagnosis and testing»:

    Base brake system

    Brake lamp switch

    Red brake warning lamp

    Master cylinder/power booster

    Combination valve

    Disc brake rotor

    Brake drum

    Brake line and hoses

    Brake fluid contamination

    Jeep Cherokee Service Manual / Brakes / Base brake system / Diagnosis and testing / Brake lamp switch

    Jeep Cherokee Service Manual

    Categories


    © 2017-2023 Copyright www.jcherokee.com