REMOVAL
(1) Remove lower steering column cover. Refer to Group 8E, Instrument Panel and Gauges, for proper procedure.
(2) Remove lower steering column shroud. Refer to Group 19, Steering, for proper procedure.
(3) Remove tie strap near the solenoid retaining the brake transmission interlock cable to the steering column.
(4) Disengage wire connector from solenoid.
(5) With the ignition removed or in the unlocked position, disengage lock tab holding cable end to steering column (Fig. 57).
(6) Pull cable end from steering column.
(7) Remove the floor console and related trim.
Refer to Group 23, Body, for proper procedure.
(8) Disconnect the cable eyelet from the bellcrank (Fig. 58).
(9) Disconnect and remove the cable from the shift bracket.
Fig. 57 Brake/Park Interlock Cable
1 - IGNITION LOCK
2 - LOCK TAB
3 - CABLE END
INSTALLATION
(1) Route replacement cable behind instrument panel and under floor console area to shift mechanism (Fig. 58).
(2) Insert cable end into opening in steering column hub under ignition lock. Push cable inward until lock tab engages.
(3) Connect the cable end eyelet onto shifter bellcrank pin.
(4) Place gear selector in PARK.
(5) Push the spring-loaded cable adjuster forward and snap cable into bracket.
(6) Adjust the brake transmission shifter interlock cable. Refer to the Adjustment portion of this section for proper procedures.
(7) Verify that the cable adjuster lock clamp is pushed downward to the locked position.
(8) Test the park-lock cable operation.
(9) Install the floor console and related trim.
Fig. 58 Cable and Shifter
1 - SHIFT MECHANISM
2 - LOCK-TAB
3 - IGNITION LOCK INTERLOCK
4 - STEERING COLUMN
5 - SOLENOID
6 - WIRE CONNECTOR
7 - LEVER
8 - MOUNT BRACKET
9 - SHIFT CABLE
10 - AUTOMATIC TRANSMISSION
11 - TIE STRAP
12 - PARK/BRAKE INTERLOCK CABLE
(10) Install tie strap to hold cable to base of steering column.
(11) Install lower steering column shroud and ignition lock.
(12) Install lower steering column cover.