Toyota
Jeep Cherokee
 Service Manual
Ignition system » Removal and installation
Camshaft position sensor-2.5L engine

On 2.5L engines, the camshaft position sensor is located in the distributor (Fig. 27).

REMOVAL

Distributor removal is not necessary to remove camshaft position sensor.

(1) Disconnect negative battery cable at battery.

(2) Remove distributor cap from distributor (two screws).

(3) Disconnect camshaft position sensor wiring harness from main engine wiring harness

Fig. 27 Camshaft Position Sensor-2.5L Engine
Fig. 27 Camshaft Position Sensor-2.5L Engine

1 - SYNC SIGNAL GENERATOR
2 - CAMSHAFT POSITION SENSOR
3 - PULSE RING
4 - DISTRIBUTOR ASSEMBLY

(4) Remove distributor rotor from distributor shaft.

(5) Lift camshaft position sensor assembly from distributor housing (Fig. 27).

INSTALLATION

(1) Install camshaft position sensor to distributor.

Align sensor into notch on distributor housing.

(2) Connect wiring harness.

(3) Install rotor.

(4) Install distributor cap. Tighten mounting screws.

    More about «Removal and installation»:

    Spark plug cables

    Spark plugs

    Ignition coil-2.5L engine

    Ignition coil-4.0L engine

    Crankshaft position (CKP) sensor

    Camshaft position sensor-2.5L engine

    Camshaft position sensor-4.0L engine

    Distributor-2.5L engine

    Ignition switch and key cylinder

    Shifter/ignition interlock

    Jeep Cherokee Service Manual / Ignition system / Removal and installation / Camshaft position sensor-2.5L engine

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com