(1) Disconnect and isolate the battery negative cable.
(2) Remove the screws that secure the front door trim panel to the inner door panel (Fig. 4).
(3) Using a trim stick or another suitable wide flat-bladed tool, gently pry the front door trim panel away from the door around the perimeter to release the trim panel retainers.
NOTE: To aid in the removal of the trim panel, start at the bottom of the panel.
(4) Lift the front door trim panel upwards and away from the inner door panel far enough to disengage the top of the panel from the inner belt weatherstrip.
(5) Pull the front door trim panel away from the inner door panel far enough to access the inside door latch release and lock linkage rods near the back of the inside door remote controls.
(6) Unsnap the plastic retainer clips from the inside door remote control ends of the latch release and lock linkage rods, and remove the rod ends from the inside door remote controls.
Fig. 4 Front Door Trim Panel Remove/Install
1 - U-NUT
2 - DOOR
3 - TRIM PANEL
4 - PUSH-IN FASTENER
(7) Unplug the wire harness connectors from the door module.
(8) Remove the trim panel from the front door.
(9) Remove the three screws that secure the door module to the front door trim panel (Fig. 5).
Fig. 5 Door Module Remove/Install
1 - INSIDE DOOR LATCH AND LOCK REMOTE CONTROLS
2 - CONNECTOR 1 RECEPTACLE
3 - DOOR MODULE
4 - CONNECTOR 2 RECEPTACLE
5 - SCREWS
6 - DOOR TRIM PANEL
(10) Remove the door module from the front door trim panel.
(11) Reverse the removal procedures to install.
Tighten the mounting screws to 2.2 N·m (20 in. lbs.).