Toyota
Jeep Cherokee
 Service Manual
Steering » Steering linkage » Removal and installation
Drag link

REMOVAL

(1) Remove cotter pins and nuts from drag link (2) Remove the steering damper ball stud from the drag link.

(3) Remove tie rod from drag link (4) Remove drag link from the steering knuckle and pitman arm.

INSTALLATION

(1) Install the drag link onto steering knuckle and pitman arm.

(2) Install nut at steering knuckle and tighten to 47 N·m (35 ft. lbs.). Install new cotter pins.

(3) Install nut at pitman arm and tighten to 74 N·m (55 ft. lbs.). Install new cotter pins.

(4) Install tie rod onto drag link and install nut.

Tighten nut to 74 N·m (55 ft. lbs.) and install new cotter pins.

(5) Install steering damper onto drag link and install nut. Tighten nut to 74 N·m (55 ft. lbs.) and install a new cotter pin.

    More about «Removal and installation»:

    Tie rod

    Pitman ARM

    Drag link

    Steering damper

    Jeep Cherokee Service Manual / Steering / Steering linkage / Removal and installation / Drag link

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com