Toyota
Jeep Cherokee
 Service Manual
Engine » 2.5L engine » Removal and installation
Engine mount-rear

A resilient rubber cushion supports the transmission at the rear between the transmission extension housing and the rear support crossmember or skid plate.

Fig. 43 Engine Support Bracket-Right Side
Fig. 43 Engine Support Bracket-Right Side

1 - ENGINE SUPPORT BRACKET

Fig. 44 Support Cushion Bracket-Left Side
Fig. 44 Support Cushion Bracket-Left Side

1 - LOWER FRONT SILL
2 - TRACK BAR MOUNTING PLATE
3 - SUPPORT CUSHION BRACKET

REMOVAL

(1) Disconnect negative cable from battery.

(2) Raise the vehicle and support the transmission.

(3) Remove the nuts holding the support cushion to the crossmember (Fig. 45) (Fig. 46). Remove the crossmember.

MANUAL TRANSMISSION: a. Remove the support cushion nuts and remove the cushion.

b. If necessary, remove the bolts holding the transmission support bracket to the transmission (Fig. 45).

Remove the bracket.

Fig. 45 Rear Mount (Manual Transmission)
Fig. 45 Rear Mount (Manual Transmission)

1 - TRANSMISSION SUPPORT BRACKET
2 - SUPPORT CUSHION

AUTOMATIC TRANSMISSION:

a. Remove the support cushion bolts and remove the cushion and the transmission support bracket.

b. If necessary on 2WD vehicles, remove the bolts holding the transmission support adaptor bracket to the transmission (Fig. 46). Remove the adaptor bracket.

INSTALLATION

MANUAL TRANSMISSION: a. If removed, position the transmission support bracket to the transmission and install the bolts.

Tighten the bolts to 43 N·m (32 ft. lbs.) torque.

b. Position the support cushion onto the transmission support bracket. Install and tighten the nuts to 46 N·m (34 ft. lbs.) torque.

AUTOMATIC TRANSMISSION: a. If removed, position the transmission support adaptor bracket (2WD vehicles) to the transmission and install the bolts. Tighten the bolts to 75 N·m (55 ft. lbs.) torque.

b. Position the transmission support bracket and support cushion to the transmission and install the bolts. Tighten the bolts to 75 N·m (55 ft. lbs.) torque.

(1) Position the crossmember onto the support cushion studs and install the nuts. Tighten the nuts to 22 N·m (192 in. lbs.) torque.

(2) Install the crossmember to sill bolts and tighten to 41 N·m (30 ft. lbs.) torque.

(3) Remove the transmission support.

(4) Lower the vehicle.

(5) Connect negative cable to battery.

Fig. 46 Rear Mount (Automatic Transmission)

Fig. 46 Rear Mount (Automatic Transmission)

1 - 434
2 - 234
3 - TRANSMISSION SUPPORT ADAPTOR BRACKET
4 - SUPPORT CUSHION
5 - CROSSMEMBER ASSEMBLY
6 - TRANSMISSION SUPPORT BRACKET

    More about «Removal and installation»:

    Engine mounts-front

    Engine mount-rear

    Engine

    Intake manifold

    Exhaust manifold

    Cylinder head cover

    Rocker arms and push rods

    Valve spring and seal

    Cylinder head

    Cylinder head

    Hydraulic tappets

    Vibration damper

    Timing case cover oil seal

    Timing case cover

    Timing chain and sprockets

    Camshaft

    Camshaft pin replacement

    Camshaft bearings

    Crankshaft main bearings

    Oil pan

    Oil pump

    Piston and connecting rod

    Rear main oil seal

    Jeep Cherokee Service Manual / Engine / 2.5L engine / Removal and installation / Engine mount-rear

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com