Toyota
Jeep Cherokee
 Service Manual
Engine » 4.0L engine » Removal and installation
Engine mount-rear

A resilient rubber cushion supports the transmission at the rear between the transmission extension housing and the rear support crossmember or skid plate.

REMOVAL

(1) Disconnect negative cable from battery.

(2) Raise the vehicle and support the transmission.

(3) Remove the nuts holding the support cushion to the crossmember (Fig. 46) (Fig. 47). Remove the crossmember.

Fig. 45 Support Cushion Bracket
Fig. 45 Support Cushion Bracket

1 - SUPPORT CUSHION BRACKET
2 - SUPPORT CUSHION BRACKET

MANUAL TRANSMISSION

(Fig. 46) a. Remove the support cushion nuts and remove the cushion.

b. Remove the transmission support bracket bolts and remove the bracket from the transmission.

AUTOMATIC TRANSMISSION

(Fig. 47) a. Remove the support cushion bolts and remove the cushion and the support bracket from the transmission (4WD) or from the adaptor bracket (2WD).

b. On 2WD vehicles, remove the bolts holding the transmission support adaptor bracket to the transmission (Fig. 47). Remove the adaptor bracket.

INSTALLATION

MANUAL TRANSMISSION:

a. Install the transmission support bracket to the transmission. Install the bolts and tighten to 46 N·m (34 ft. lbs.) torque.

Fig. 46 Rear Mount(Manual Transmission)
Fig. 46 Rear Mount(Manual Transmission)

1 - TRANSMISSION SUPPORT BRACKET
2 - SUPPORT CUSHION
3 - CROSSMEMBER ASSEMBLY

b. Install the support cushion to the support bracket. Install the nuts and tighten to 75 N·m (55 ft. lbs.) torque.

AUTOMATIC TRANSMISSION:

a. On 2WD vehicles, position the transmission support adaptor bracket to the transmission. Install the bolts and tighten to 75 N·m (55 ft. lbs.) torque.

b. Position the transmission support bracket and support cushion to the adaptor bracket (2WD) or the transmission (4WD). Install the bolts and tighten to 75 N·m (55 ft. lbs.) torque.

(1) Position the crossmember onto the support cushion studs. Install the stud nuts and tighten to 22 N·m (192 in. lbs) torque.

(2) Install crossmember-to-sill bolts and tighten to 41 N·m (30 ft. lbs.) torque.

(3) Remove the transmission support.

(4) Lower the vehicle.

(5) Connect negative cable to battery.

    More about «Removal and installation»:

    Engine mounts-front

    Engine mount-rear

    Engine assembly

    Intake and exhaust manifold

    Exhaust manifold-4.0L engine

    Cylinder head cover

    Rocker arms and push rods

    Valve springs and oil seals

    Cylinder head

    Valves and valve springs

    Hydraulic tappets

    Vibration damper

    Timing case cover

    Timing chain and sprockets

    Camshaft

    Camshaft bearings

    Crankshaft main bearings

    Oil pan

    Pistons and connecting rods

    Crankshaft oil seals-rear

    Oil pump

    Timing case cover oil seal

    Jeep Cherokee Service Manual / Engine / 4.0L engine / Removal and installation / Engine mount-rear

    Jeep Cherokee Service Manual

    Categories


    © 2017-2022 Copyright www.jcherokee.com