Jeep Cherokee Service ManualTransmission and transfer case » Automatic transmission-30RH » Removal and installation
Extension housing bushing
Jeep Cherokee
Service Manual
Extension housing bushing
REMOVAL
(1) Remove housing yoke seal.
(2) Insert Remover 6957 into extension housing.
Tighten tool to bushing and remove bushing (Fig.
73).
INSTALLATION
(1) Align bushing oil hole with oil slot in extension housing.
(2) Tap bushing into place with Installer 6951 and Handle C-4171.
(3) Install new oil seal in housing using Seal Installer C-3995-A (Fig. 74).
More about «Removal and installation»:
Transmission
Torque converter
Yoke seal replacement
Extension housing bushing
Adapter housing
Speedometer adapter
Park/neutral position switch
Gearshift cable
Brake transmission shift interlock
Valve body
Output shaft rear bearing
Governor and park gear
Park lock
Jeep Cherokee Service Manual / Transmission and transfer case / Automatic transmission-30RH / Removal and installation / Extension housing bushing
Jeep Cherokee Service Manual
- Lubrication and maintenance
- Suspension
- Differential and driveline
- Brakes
- Clutch
- Cooling system
- Battery
- Starting systems
- Charging system
- Ignition system
- Instrument panel systems
- Audio systems
- Horn systems
- Speed control system
- Turn signal and hazard warning systems
- Wiper and washer systems
- Lamps
- Passive restraint systems
- Electrically heated systems
- Power distribution systems
- Power lock systems
- Vehicle theft/security systems
- Power seat systems
- Power window systems
- Power mirror systems
- Chime/buzzer warning systems
- Overhead console systems
- Engine
- Exhaust system
- Frame and bumpers
- Frame
- Fuel system
- Steering
- Transmission and transfer case
- Tires and wheels
- Body
Categories
© 2017-2024 Copyright www.jcherokee.com