REMOVAL
(1) Raise and support vehicle.
(2) Remove propeller shaft. Refer to Group 3, Differential and Driveline, for proper procedures.
(3) Using a suitable seal puller or screw with a slide hammer, remove the extension housing seal (Fig. 11).
Fig. 11 Remove Extension Housing Seal
1 - SLIDE HAMMER
2 - SEAL PULLER
3 - 2WD EXTENSION HOUSING
INSTALLATION
(1) Clean seal bore of extension housing of any residual sealer material from original seal.
(2) Using Tool Handle C-4171 and Seal Installer 8212, install new extension housing seal so that the seal is located 0 6 0.5 mm (0 6 0.02 in.) to the face of the extension housing (Fig. 12).
(3) Install propeller shaft. Refer to Group 3, Differential and Driveline, for proper procedures.
(4) Check and add fluid to transmission as necessary.
Refer to the Recommended Lubricant section for proper fluid requirements.
(5) Lower vehicle.