Jeep Cherokee

 Service Manual

Fuel system » Fuel injection system » Removal and installation
Fuel pump relay

The fuel pump relay is located in the Power Distribution Center (PDC) (Fig. 23). Refer to label on PDC cover for relay location.

REMOVAL

(1) Remove PDC cover.

(2) Remove relay from PDC.

(3) Check condition of relay terminals and PDC connector terminals for damage or corrosion. Repair if necessary before installing relay.

(4) Check for pin height (pin height should be the same for all terminals within the PDC connector).

Repair if necessary before installing relay.

INSTALLATION

(1) Install relay to PDC.

(2) Install cover to PDC.

Automatic shutdown (asd) relay

Fuel pump relay

Throttle body

Throttle position sensor (TPS)

Idle air control (IAC) motor

Manifold absolute pressure (map) sensor

Powertrain control module (PCM)

Power steering pressure switch- 2.5L engine

Oxygen sensor

Air cleaner element (filter)

Engine coolant temperature sensor

Intake manifold air temperature sensor

Vehicle speed sensor