Toyota
Jeep Cherokee
 Service Manual
Fuel system » Fuel delivery system » Description and operation
Fuel tubes/lines/hoses and clamps

DESCRIPTION

Also refer to Quick-Connect Fittings.

WARNING: THE FUEL SYSTEM IS UNDER A CONSTANT PRESSURE (EVEN WITH THE ENGINE OFF).

BEFORE SERVICING ANY FUEL SYSTEM HOSES, FITTINGS OR LINES, THE FUEL SYSTEM PRESSURE MUST BE RELEASED. REFER TO THE FUEL SYSTEM PRESSURE RELEASE PROCEDURE IN THIS GROUP.

The lines/tubes/hoses used on fuel injected vehicles are of a special construction. This is due to the higher fuel pressures and the possibility of contaminated fuel in this system. If it is necessary to replace these lines/tubes/hoses, only those marked EFM/EFI may be used.

If equipped: The hose clamps used to secure rubber hoses on fuel injected vehicles are of a special rolled edge construction. This construction is used to prevent the edge of the clamp from cutting into the hose. Only these rolled edge type clamps may be used in this system. All other types of clamps may cut into the hoses and cause high-pressure fuel leaks.

Use new original equipment type hose clamps.

    More about «Description and operation»:

    PCM vin reprogramming

    Fuel delivery system

    Fuel pump module

    Fuel pump

    Fuel gauge sending unit

    Fuel filter/fuel pressure regulator

    Fuel tank

    Fuel injectors

    Fuel injector rail/fuel damper-2.5L engine

    Fuel rail/fuel damper-4.0L engine

    Fuel tank filler tube cap

    Fuel tubes/lines/hoses and clamps

    Quick-connect fittings

    Jeep Cherokee Service Manual / Fuel system / Fuel delivery system / Description and operation / Fuel tubes/lines/hoses and clamps

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com