Toyota
Jeep Cherokee
 Service Manual
Transmission and transfer case » Automatic transmission-30RH » Adjustments
Gearshift cable

Check adjustment by starting the engine in Park and Neutral. Adjustment is OK if the engine starts only in these positions. Adjustment is incorrect if the engine starts in one but not both positions. If the engine starts in any position other than Park or Neutral, or if the engine will not start at all, the park/ neutral position switch may be faulty.

Gearshift Adjustment Procedure

(1) Shift transmission into Park.

(2) Raise vehicle.

(3) Release cable adjuster clamp (at transmission end of cable) to unlock cable.

(4) Unsnap cable from cable mounting bracket on transmission (Fig. 228).

(5) Slide cable eyelet off transmission shift lever.

(6) Verify transmission shift lever is in Park detent by moving lever fully rearward. Last rearward detent is Park position.

(7) Verify positive engagement of transmission park lock by attempting to rotate propeller shaft.

Shaft will not rotate when park lock is engaged.

(8) Slide cable eyelt onto transmission shift lever.

(9) Snap shift cable adjuster into mounting bracket on transmission.

(10) Lock shift cable by pressing cable adjuster clamp down until it snaps into place.

(11) Lower vehicle and check engine starting.

Engine should start only in Park and Neutral.

Fig. 228 Shift Cable Attachment At Transmission-Typical
Fig. 228 Shift Cable Attachment At Transmission-Typical

1 - THROTTLE VALVE CABLE
2 - TRANSMISSION SHIFT LEVER
3 - SHIFT CABLE
4 - SHIFT CABLE BRACKET

    More about «Adjustments»:

    Gearshift cable

    Brake transmission shift interlock cable adjustment

    Transmission throttle valve cable adjustment

    Front band adjustment

    Rear band adjustment

    Valve body

    Jeep Cherokee Service Manual / Transmission and transfer case / Automatic transmission-30RH / Adjustments / Gearshift cable

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com