Toyota
Jeep Cherokee
 Service Manual
Body » Body component service » Removal and installation
Headliner

The upper trim moldings and the headliner are attached to the roof rail with a combination of screws, clip retainers and rail retainers (Fig. 83).

To remove a headliner, all of the upper trim moldings must be removed from the perimeter of the headliner along with (as applicable):

Fig. 82 Sunvisor w/Vanity Lamp
Fig. 82 Sunvisor w/Vanity Lamp

1 - HEADLINER
2 - SUPPORT CLIP
3 - SUNVISOR

Fig. 83 Headliner Trim Moldings
Fig. 83 Headliner Trim Moldings

1 - ROOF RAIL
2 - HEADLINER MOULDING
3 - SCREW
4 - SPACER
5 - LIFTGATE PILLAR TRIM COVER
6 - ASSIST HANDLE
7 - SCREW
8 - ASSIST HANDLE
9 - WINDSHIELD SIDE MOULDING
10 - COVER PLUG
11 - SCREW

  • Assist handles.
  •  Sunvisors.
  •  Dome/cargo lamps.
  •  Overhead console.
  •  All other attached/overlapping components.

Refer to the appropriate removal and installation procedure locate in this section or in Group 8, Electrical.

REMOVAL

CAUTION: The headliner is a one-piece, molded component (Fig. 84). It has limited flexibility and must not be bent during removal/installation.

(1) Remove the upper trim moldings from the perimeter of the headliner (Fig. 85).

(2) Ensure that all the retainer clips and screws are disengaged before removing the headliner.

(3) Disengage tabs attaching headliner/speaker structure to roof rail, if equipped (Fig. 84).

(4) Disengage rear speaker harness connector, if equipped.

Fig. 84 Headliner
Fig. 84 Headliner

1 - TAB
2 - SPEAKER
3 - GRILLE
4 - CARGO LAMP
5 - HEADLINER

INSTALLATION

(1) Engage tabs attaching headliner/speaker structure to roof rail, if equipped. (Fig. 84) (2) On vehicles without headliner speakers, ensure that the retainer clips on upper liftgate opening trim and rails are installed. (Fig. 86) (3) Engage rear speaker harness connector.

(4) Install the upper trim moldings around the perimeter of the headliner. Tighten the retaining screws to 1 N·m (11 in. lbs.) torque.

(5) As applicable, install:

  •  Assist handles.
  •  Sunvisors.
  •  Dome/cargo lamps.
  •  Overhead console.

Fig. 85 Upper Trim Molding-4-Door
Fig. 85 Upper Trim Molding-4-Door

1 - ROOF RAIL
2 - SCREW
3 - SPACER
4 - ROOF RAIL
5 - HEADLINER SLOT
6 - SPACER
7 - REAR HEADLINER TRIM MOLDING
8 - FRONT HEADLINER TRIM MOLDING
9 - TRIM MOLDING

  • All other attached/overlapping components.

Fig. 86 Headliner Retainer Clip and Retainer Rail
Fig. 86 Headliner Retainer Clip and Retainer Rail

1 - CLIP
2 - RETAINER REAR

    More about «Removal and installation»:

    Grille

    Grille opening panel (gop)

    Hood

    Hood hinge

    Hood latch

    Hood latch striker

    Hood release cable

    Hood safety latch

    Safety latch striker

    Hood silencer pad

    Cowl weatherstrip

    Cowl grille

    Body decals

    Exterior nameplates

    Side view mirror

    Front fender flare

    Front wheelhouse liner

    Right front fender

    Left front fender

    Front door trim panel

    Front door waterdam

    Front door

    Front door hinge

    Front door restraint

    Front door outside handle

    Front door lock cylinder

    Lock cylinders

    Front door latch

    Front door latch striker

    Front door inside handle actuator

    Front door inner belt weatherstrip

    Front door outer belt weatherstrip

    Front door glass run channel weatherstrip

    Front door opening weatherstrip

    Front door opening secondary weatherstrip

    Front door glass exterior molding

    Front door window regulator

    Front door spacer blocks-twodoor vehicles

    Front door glass

    Rear door trim panel

    Rear door waterdam

    Rear door

    Rear door restraint

    Rear door hinge

    Rear door outside handle

    Rear door latch

    Rear door latch striker

    Rear door inside handle actuator

    Rear door inner belt weatherstrip

    Rear door outer belt weatherstrip

    Rear door glass run channel weatherstrip

    Rear door glass exterior molding

    Rear door weatherstrip

    Rear door window regulator

    Rear door window glass

    Body side molding

    Rear fender flare

    Quarter window applique

    Drip rail molding

    Luggage rack

    Air exhaust grille

    A-pillar trim

    Lower a-pillar cowl trim

    Front inner scuff plate

    Door sill scuff plate

    Assist handle

    B-pillar trim

    C-pillar trim

    Quarter panel trim extension

    Quarter panel trim and wheelhouse cover

    Liftgate pillar trim

    Liftgate opening upper trim

    Liftgate scuff plate

    Front shoulder belt/buckle

    Rear shoulder/lap belt/buckle

    Full floor console

    Front carpet/mat

    Rear carpet/mat

    Rearview mirror

    Rearview mirror support bracket

    Sunvisors

    Headliner

    Liftgate trim panel

    Liftgate

    Liftgate hinge

    Liftgate support rod cylinder

    Liftgate support rod ball stud

    Liftgate outside handle

    Liftgate latch

    Liftgate latch striker

    Liftgate weatherstrip

    Jeep Cherokee Service Manual / Body / Body component service / Removal and installation / Headliner

    Jeep Cherokee Service Manual

    Categories


    © 2017-2022 Copyright www.jcherokee.com