Jeep Cherokee

 Service Manual

Clutch » Diagnosis and testing
Installation methods and parts usage

Distortion of clutch components during installation and the use of non-standard components are common causes of clutch malfunction.

Improper clutch cover bolt tightening can distort the cover. The usual result is clutch grab, chatter and rapid wear. Tighten the cover bolts as described in Removal and Installation section.

An improperly seated flywheel and/or clutch housing are additional causes of clutch failure. Improper seating will produce misalignment and additional clutch problems.

The use of non-standard or low quality parts will also lead to problems and wear. Use recommended factory quality parts to avoid comebacks.

A cocked pilot bearing is another cause of clutch noise, drag, hard shifting, and rapid bearing wear.

Always use an alignment tool to install a new bearing.

This practice helps avoid cocking the bearing during installation.

Safety precautions

Installation methods and parts usage

Clutch diagnostic information

Clutch contamination

Improper clutch release or engagement

Clutch misalignment

Clutch housing misalignment

Clutch flywheel runout

Clutch cover and disc runout

Clutch diagnosis charts