Jeep Cherokee

 Owners Manual

Things to know before starting your vehicle » Occupant restraint systems » Seat Belt Systems
Lap/Shoulder Belt Operating Instructions

1. Enter the vehicle and close the door. Sit back and adjust the seat.

2. The seat belt latch plate is above the back of the front seat, and next to your arm in the rear seat (for vehicles equipped with a rear seat). Grasp the latch plate and pull out the seat belt. Slide the latch plate up the webbing as far as necessary to allow the seat belt to go around your lap.

Pulling Out The Latch Plate

3. When the seat belt is long enough to fit, insert the latch plate into the buckle until you hear a "click."

Inserting Latch Plate Into Buckle

4. Position the lap belt so that it is snug and lies low across your hips, below your abdomen. To remove slack in the lap belt portion, pull up on the shoulder belt. To loosen the lap belt if it is too tight, tilt the latch plate and pull on the lap belt. A snug seat belt reduces the risk of sliding under the seat belt in a collision.

Positioning The Lap Belt

5. Position the shoulder belt across the shoulder and chest with minimal, if any slack so that it is comfortable and not resting on your neck. The retractor will withdraw any slack in the shoulder belt.

6. To release the seat belt, push the red button on the buckle. The seat belt will automatically retract to its stowed position. If necessary, slide the latch plate down the webbing to allow the seat belt to retract fully.

Initial Indication

Change Of Status

Lap/Shoulder Belts

Lap/Shoulder Belt Operating Instructions

Lap/Shoulder Belt Untwisting Procedure

Adjustable Upper Shoulder Belt Anchorage

Seat Belt Extender

Seat Belts And Pregnant Women

Seat Belt Pretensioner

Switchable Automatic Locking Retractor (ALR)

How To Disengage The Automatic Locking Mode