Toyota
Jeep Cherokee
 Service Manual
Transmission and transfer case » AW-4 automatic transmission » Service procedures
Oil pump volume check

Measuring the oil pump output volume will determine if sufficient oil flow to the transmission oil cooler exists, and whether or not an internal transmission failure is present.

Verify that the transmission fluid is at the proper level. Refer to the Fluid Level Check procedure in this section. If necessary, fill the transmission to the proper level with Mopart ATF+3, type 7176, Automatic Transmission Fluid.

(1) Disconnect the To cooler line at the cooler inlet and place a collecting container under the disconnected line.

CAUTION: With the fluid set at the proper level, fluid collection should not exceed (1) quart or internal damage to the transmission may occur.

(2) Run the engine at curb idle speed , with the shift selector in neutral.

(3) If one quart of transmission fluid is collected in the container in 20 seconds or less, oil pump flow volume is within acceptable limits. If fluid flow is intermittent, or it takes more than 20 seconds to collect one quart of fluid, refer to the Hydraulic Pressure tests in this section for further diagnosis.

(4) Re-connect the To cooler line to the transmission cooler inlet.

(5) Refill the transmission to proper level.

    More about «Service procedures»:

    Checking fluid level

    Checking fluid condition

    Refilling after overhaul or fluid/ filter change

    Oil pump volume check

    Flushing coolers and tubes

    Aluminum thread repair

    Jeep Cherokee Service Manual / Transmission and transfer case / AW-4 automatic transmission / Service procedures / Oil pump volume check

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com