Jeep Cherokee

 Service Manual

Transmission and transfer case » Automatic transmission-30RH » Removal and installation
Output shaft rear bearing

REMOVAL

(1) Remove extension housing.

(2) Remove snap ring that retains rear bearing on output shaft (Fig. 84).

(3) Remove bearing from output shaft.

INSTALLATION

(1) Install bearing on output shaft. Be sure retaining ring groove in outer circumference of bearing is toward the governor.

(2) Install rear bearing retaining snap ring (Fig.

84).

(3) Install extension housing.

Fig. 84 Output Shaft Rear Bearing-Typical

1 - BEARING SNAP RING GROOVE
2 - PARK LOCK CONTROL ROD
3 - REAR SNAP RING

Transmission

Torque converter

Yoke seal replacement

Extension housing bushing

Adapter housing

Speedometer adapter

Park/neutral position switch

Gearshift cable

Brake transmission shift interlock

Valve body

Output shaft rear bearing

Governor and park gear

Park lock