Toyota
Jeep Cherokee
 Service Manual
Transmission and transfer case » Automatic transmission-30RH » Removal and installation
Park/neutral position switch

REMOVAL

(1) Raise vehicle and position drain pan under switch.

(2) Disconnect switch wires.

(3) Remove switch from case.

Fig. 76 Speedometer Pinion Adapter Components
Fig. 76 Speedometer Pinion Adapter Components

1 - SENSOR O-RING
2 - SPEEDOMETER ADAPTER> 3 - ADAPTER O-RING> 4 - SPEEDOMETER PINION> 5 - ADAPTER CLAMP> 6 - VEHICLE SPEED SENSOR

INSTALLATION

(1) Move shift lever to Park and Neutral positions.

Verify that switch operating lever fingers are centered in switch opening in case (Fig. 78).

Fig. 78 Park/Neutral Position Switch
Fig. 78 Park/Neutral Position Switch

1 - NEUTRAL CONTACT
2 - MANUAL LEVER AND SWITCH PLUNGER IN REVERSE POSITION
3 - PARK CONTACT
4 - SWITCH

2) Install new seal on switch and install switch in case. Tighten switch to 34 N·m (25 ft. lbs.) torque.

(3) Test continuity of new switch with 12V test lamp.

(4) Connect switch wires and lower vehicle.

(5) Top off transmission fluid level.

    More about «Removal and installation»:

    Transmission

    Torque converter

    Yoke seal replacement

    Extension housing bushing

    Adapter housing

    Speedometer adapter

    Park/neutral position switch

    Gearshift cable

    Brake transmission shift interlock

    Valve body

    Output shaft rear bearing

    Governor and park gear

    Park lock

    Jeep Cherokee Service Manual / Transmission and transfer case / Automatic transmission-30RH / Removal and installation / Park/neutral position switch

    Jeep Cherokee Service Manual

    Categories


    © 2017-2022 Copyright www.jcherokee.com