Jeep Cherokee
Service Manual
Transmission and transfer case » AW-4 automatic transmission » Removal and installation
Park rod and pawl

REMOVAL

(1) Remove valve body as outlined in this section.

(2) Remove bolts attaching park rod bracket to case (Fig. 88).

(3) Remove park rod from manual valve shaft sector (Fig. 89).

(4) Remove park rod.

Fig. 88 Removing/Installing Park Rod Bracket

1 - PARK ROD BRACKET

Fig. 89 Removing/Installing Park Rod

1 - SHIFT SECTOR
2 - MANUAL VALVE SHAFT
3 - PARK ROD

(5) Remove park pawl, pin and spring (Fig. 90).

INSTALLATION

(1) Examine park rod, pawl, pin and spring.

Replace any component that is worn or damaged.

(2) Install pawl in case. Insert pin and install spring.

Be sure spring is positioned as shown in Figure 35.

(3) Install park rod and bracket (Fig. 88). Tighten bracket bolts to 10 N·m (7 ft. lbs.) torque.

(4) Install valve body, oil screen and oil pan.

More about «Removal and installation»:

Transmission and torque converter