Toyota
Jeep Cherokee
 Service Manual
Power lock systems » Removal and installation
Power lock motor

FRONT DOOR

The front door power lock motor is integral to the front door latch unit. If the front door power lock motor is faulty or damaged, the entire latch unit must be replaced. Refer to Group 23 - Body for the front door latch service procedures.

REAR DOOR

The rear door power lock motor is integral to the rear door latch unit. If the rear door power lock motor is faulty or damaged, the entire latch unit must be replaced. Refer to Group 23 - Body for the rear door latch service procedures.

LIFTGATE

(1) Disconnect and isolate the battery negative cable.

(2) Open the liftgate.

(3) Remove the liftgate trim panel from the liftgate.

Refer to Group 23 - Body for the procedures.

(4) Reach through the liftgate inner panel access hole and disconnect the link from the clip on the power lock motor (Fig. 5).

Fig. 5 Liftgate Power Lock Motor Remove/Install
Fig. 5 Liftgate Power Lock Motor Remove/Install

1 - CLIPS
2 - LOCK LEVER
3 - LINK
4 - MOTOR
5 - LIFTGATE INNER PANEL
6 - SCREW
7 - CONNECTORS

(5) Remove the two screws that secure the power lock motor to the liftgate inner panel.

(6) Pull the power lock motor out through the liftgate inner panel access hole far enough to access the wire harness connector.

(7) Unplug the wire harness connector from the power lock motor.

(8) Remove the power lock motor from the liftgate.

(9) Reverse the removal procedures to install.

Tighten the power lock motor mounting screws to 3 N·m (28 in. lbs.).

    More about «Removal and installation»:

    Door module

    Power lock motor

    Remote keyless entry receiver

    Jeep Cherokee Service Manual / Power lock systems / Removal and installation / Power lock motor

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com