Jeep Cherokee Service ManualPower mirror systems » Removal and installation
Power mirror switch
Power mirror switch
This procedure covers removal of the stand-alone type power mirror switch. Vehicles with power windows and power locks have a power mirror switch which is integral to the Driver Door Module (DDM).
See Door Module in this group for the DDM-type power mirror switch service procedures.
Fig. 2 Driver Door Module Power Mirror Switch Continuity
(1) Disconnect and isolate the battery negative cable.
(2) Using a trim stick or another suitable wide flat-bladed tool, gently pry around the perimeter edge of the switch to release the snap clips that secure the switch to the trim panel (Fig. 4).
(3) Pull the power mirror switch away from the trim panel far enough to access the wire harness connector.
(4) Unplug the power mirror switch from the wire harness connector.
(5) Reverse the removal procedures to install.
Power mirror switch
Door module
Power mirror
Jeep Cherokee Service Manual
- Lubrication and maintenance
- Suspension
- Differential and driveline
- Brakes
- Clutch
- Cooling system
- Battery
- Starting systems
- Charging system
- Ignition system
- Instrument panel systems
- Audio systems
- Horn systems
- Speed control system
- Turn signal and hazard warning systems
- Wiper and washer systems
- Lamps
- Passive restraint systems
- Electrically heated systems
- Power distribution systems
- Power lock systems
- Vehicle theft/security systems
- Power seat systems
- Power window systems
- Power mirror systems
- Chime/buzzer warning systems
- Overhead console systems
- Engine
- Exhaust system
- Frame and bumpers
- Frame
- Fuel system
- Steering
- Transmission and transfer case
- Tires and wheels
- Body
Categories
