Jeep Cherokee Service ManualPower seat systems » Removal and installation
Power seat switch
Power seat switch
(1) Disconnect and isolate the battery negative cable.
(2) Remove the three screws that secure the seat cushion side shield to the outboard seat cushion frame.
(3) Pull the seat cushion side shield away from the seat cushion frame far enough to access the power seat switch wire harness connector.
(4) Unplug the wire harness connector from the power seat switch.
(5) Remove the seat cushion side shield from the seat.
(6) Remove the two screws that secure the power seat switch to the inside of the seat cushion side shield (Fig. 2).
Fig. 2 Power Seat Switch Remove/Install
1 - SEAT SIDE SHIELD
2 - POWER SEAT SWITCH
3 - SCREWS
(7) Remove the power seat switch from the seat cushion side shield.
(8) Reverse the removal procedures to install.
Tighten the mounting screws to 2.2 N·m (20 in. lbs.).
Power seat switch
Power seat adjuster and motors
Jeep Cherokee Service Manual
- Lubrication and maintenance
- Suspension
- Differential and driveline
- Brakes
- Clutch
- Cooling system
- Battery
- Starting systems
- Charging system
- Ignition system
- Instrument panel systems
- Audio systems
- Horn systems
- Speed control system
- Turn signal and hazard warning systems
- Wiper and washer systems
- Lamps
- Passive restraint systems
- Electrically heated systems
- Power distribution systems
- Power lock systems
- Vehicle theft/security systems
- Power seat systems
- Power window systems
- Power mirror systems
- Chime/buzzer warning systems
- Overhead console systems
- Engine
- Exhaust system
- Frame and bumpers
- Frame
- Fuel system
- Steering
- Transmission and transfer case
- Tires and wheels
- Body
Categories
