This switch is not used with 4.0L six-cylinder engines.
The power steering pressure switch is installed in the power steering high-pressure hose (Fig. 32).
REMOVAL
(1) Disconnect electrical connector from power steering pressure switch.
(2) Place a small container or shop towel beneath switch to collect any excess fluid.
(3) Remove switch. Use back-up wrench on power steering line to prevent line bending
INSTALLATION
(1) Install power steering switch into power steering line.
(2) Tighten to 14-22 N·m (124-195 in. lbs.) torque.
(3) Connect electrical connector to switch.
(4) Check power steering fluid and add as necessary.
Fig. 32 Power Steering Pressure Switch
1 - POWER STEERING PRESSURE SWITCH
2 - ELECTRICAL CONNECTOR
3 - POWER STEERING PUMP
(5) Start engine and again check power steering fluid. Add fluid if necessary.