Toyota
Jeep Cherokee
 Service Manual
Steering » Power steering pump » Disassembly and assembly
Pump pulley

DISASSEMBLY

(1) Remove pump assembly.

(2) Remove pulley from pump with Puller C-4333 or equivalent puller (Fig. 5).

ASSEMBLY

NOTE: The pulley is marked front for installation.

(1) Replace pulley if bent, cracked, or loose.

(2) Install pulley on pump with Installer C-4063-B or equivalent installer (Fig. 6). The pulley must be flush with the end of the shaft. Ensure the tool and pulley are aligned with the pump shaft.

(3) Install pump assembly.

(4) With Serpentine Belt, run engine until warm (5 min.) and note any belt chirp. If chirp exists, move pulley outward approximately 0.5 mm (0.020 in.). If noise increases, press on 1.0 mm (0.040 in.). Be careful that pulley does not contact mounting bolts.

    More about «Disassembly and assembly»:

    Pump pulley

    Pump reservoir

    Jeep Cherokee Service Manual / Steering / Power steering pump / Disassembly and assembly / Pump pulley

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com