Toyota
Jeep Cherokee
 Service Manual
Steering » Power steering pump » Disassembly and assembly
Pump reservoir

DISASSEMBLY

(1) Remove power steering pump.

(2) Clean exterior of pump.

(3) Clamp the pump body in a soft jaw vice.

(4) Pry up tab and slide the retaining clips off (Fig.

7).

NOTE: Use new retaining clips for installation.

(5) Remove fluid reservoir from pump body.

Remove and discard O-ring seal.

ASSEMBLY

(1) Lubricate new O-ring Seal with Mopar Power Steering Fluid or equivalent.

Fig. 4 Pump Mounting 4.0L RHD
Fig. 4 Pump Mounting 4.0L RHD

1 - BRACKET
2 - PUMP ASSEMBLY

Fig. 5 Pulley Removal
Fig. 5 Pulley Removal

1 - POWER STEERING PUMP DRIVE PULLEY
2 - SPECIAL TOOL C-4333

(2) Install O-ring seal in housing.

(3) Install reservoir onto housing.

(4) Slide and tap in new reservoir retainer clips until tab locks to housing.

Fig. 6 Pulley Installation
Fig. 6 Pulley Installation

1 - POWER STEERING PUMP DRIVE PULLEY
2 - SPECIAL TOOL C-4063-B

(5) Install power steering pump.

(6) Add power steering fluid, refer to Pump Initial Operation.

Fig. 7 Pump Reservoir Clips
Fig. 7 Pump Reservoir Clips

1 - RESERVOIR
2 - RETAINING CLIPS

    More about «Disassembly and assembly»:

    Pump pulley

    Pump reservoir

    Jeep Cherokee Service Manual / Steering / Power steering pump / Disassembly and assembly / Pump reservoir

    Jeep Cherokee Service Manual

    Categories


    © 2017-2022 Copyright www.jcherokee.com