Jeep Cherokee Service ManualTransmission and transfer case » NV3550 manual transmission » Removal and installation
Rear housing yoke bushing
Jeep Cherokee
Service Manual
Rear housing yoke bushing
REMOVAL
(1) Remove housing yoke seal.
(2) Insert Remover 6957 into rear housing. Tighten tool to bushing and remove bushing (Fig. 12).
Fig. 12 Bushing Removal-Typical
1 - REMOVER 6957
2 - EXTENSION HOUSING BUSHING
INSTALLATION
(1) Align bushing oil hole with oil slot in rear housing.
(2) Tap bushing into place with Installer 6951 and Handle C-4171.
(3) Install new oil seal in housing using Seal Installer C-3972-A (Fig. 13).
Fig. 13 Rear Housing Seal Installation
1 - SPECIAL TOOL C-4171
2 - SPECIAL TOOL C-3972-A
More about «Removal and installation»:
Transmission
Shift tower
Yoke seal-2WD
Rear housing yoke bushing
Jeep Cherokee Service Manual / Transmission and transfer case / NV3550 manual transmission / Removal and installation / Rear housing yoke bushing
Jeep Cherokee Service Manual
- Lubrication and maintenance
- Suspension
- Differential and driveline
- Brakes
- Clutch
- Cooling system
- Battery
- Starting systems
- Charging system
- Ignition system
- Instrument panel systems
- Audio systems
- Horn systems
- Speed control system
- Turn signal and hazard warning systems
- Wiper and washer systems
- Lamps
- Passive restraint systems
- Electrically heated systems
- Power distribution systems
- Power lock systems
- Vehicle theft/security systems
- Power seat systems
- Power window systems
- Power mirror systems
- Chime/buzzer warning systems
- Overhead console systems
- Engine
- Exhaust system
- Frame and bumpers
- Frame
- Fuel system
- Steering
- Transmission and transfer case
- Tires and wheels
- Body
Categories
© 2017-2024 Copyright www.jcherokee.com