Toyota
Jeep Cherokee
 Service Manual
Transmission and transfer case » Automatic transmission-30RH » Disassembly and assembly
Rear servo piston

DISASSEMBLY

(1) Remove small snap ring and remove plug and spring from servo piston (Fig. 170).

(2) Remove and discard servo piston seal ring.

ASSEMBLY

(1) Lubricate piston and guide seals with petroleum jelly. Lubricate other servo parts with Mopart ATF Plus 3, Type 7176, transmission fluid.

(2) Install new seal ring on servo piston.

(3) Assemble piston, plug, spring and new snap ring.

(4) Lubricate piston seal lip with petroleum jelly.

Fig. 170 Rear Servo Components
Fig. 170 Rear Servo Components

1 - SNAP RING
2 - PISTON SEAL
3 - PISTON PLUG
4 - SPRING RETAINER
5 - SNAP RING
6 - PISTON SPRING
7 - CUSHION SPRING
8 - PISTON

    More about «Disassembly and assembly»:

    Governor and park gear

    Valve body

    Transmission

    Overrunning clutch/low-reverse drum

    Front servo piston

    Rear servo piston

    Oil pump and reaction shaft support

    Front clutch

    Rear clutch

    Planetary geartrain/output shaft

    Jeep Cherokee Service Manual / Transmission and transfer case / Automatic transmission-30RH / Disassembly and assembly / Rear servo piston

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com