Toyota
Jeep Cherokee
 Service Manual
Power lock systems » Removal and installation
Remote keyless entry receiver

CAUTION: A discharge of static electricity may damage this unit. At no time should any source of static electricity be permitted near this unit. Technicians handling or servicing the unit should wear cotton clothing, not synthetic fabric clothing; and, should ground themselves before and during all handling and service procedures. Electrically conductive wrist or heel straps are recommended, or static dissipating shoes are also acceptable. Work and storage areas should be free of static generative materials such as: dry air, glass, nylon, wool, fur, silk, rayon, acrylic, polystyrene foam, polyester, saran, polyethylene, polypropylene, PVC, and teflon.

MINI-DOME MOUNTED TYPE

(1) Disconnect and isolate the battery negative cable.

(2) Remove the two screws that secure the Remote Keyless Entry (RKE) mini-dome housing to the roof panel reinforcement (Fig. 6).

1 - MOUNTING TAB
2 - HEADLINER
3 - REINFORCEMENT
4 - SCREW
5 - MINI-DOME HOUSING

(3) Lower the front of the mini-dome housing and slide the unit forward to disengage the rear mounting tab from the headliner.

(4) Lower the mini-dome housing far enough to access the RKE receiver wire harness connector.

(5) Unplug the wire harness connector from the RKE receiver.

(6) Remove the RKE mini-dome unit from the headliner.

(7) Reverse the removal procedures to install.

Tighten the mounting screws to 2.8 N·m (24 in. lbs.).

OVERHEAD CONSOLE MOUNTED TYPE

(1) Disconnect and isolate the battery negative cable.

(2) Remove the overhead console from the headliner.

Refer to Overhead Console in Group 8V - Overhead Console Systems for the procedures.

(3) Remove the six screws that secure the rear overhead console housing to the overhead console bezel (Fig. 7).

(4) Gently flex the sides of the overhead console bezel far enough to clear the tabs on the rear console housing and remove the housing from the bezel.

(5) Remove the two screws that secure the RKE receiver circuit board to the rear overhead console housing.

(6) Remove the RKE circuit board from the rear overhead console housing.

(7) Reverse the removal procedures to install.

Tighten the mounting screws to 2.2 N·m (20 in. lbs.).

Fig. 7 RKE Receiver Remove/Install
Fig. 7 RKE Receiver Remove/Install

1 - REAR OVERHEAD CONSOLE HOUSING
2 - RKE RECEIVER
3 - TABS
4 - OVERHEAD CONSOLE BEZEL
5 - SCREWS

    More about «Removal and installation»:

    Door module

    Power lock motor

    Remote keyless entry receiver

    Jeep Cherokee Service Manual / Power lock systems / Removal and installation / Remote keyless entry receiver

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com