Toyota
Jeep Cherokee
 Service Manual
Transmission and transfer case » NV231 transfer case » Removal and installation
Shift lever

REMOVAL

(1) Shift transfer case into 4L.

(2) Raise vehicle.

(3) Loosen adjusting trunnion locknut and slide shift rod out of trunnion (Fig. 4). If rod lacks enough travel to come out of trunnion, push trunnion out of torque shaft.

(4) Lower vehicle.

(5) Remove console. Refer to Group 23, Body, for proper procedures.

(6) Remove screws attaching lever assembly to floorpan and remove assembly and shift rod (if left attached).

INSTALLATION

(1) If shift rod was not removed from lever assembly, work rod down through floorpan opening. Then position lever assembly on floorpan and install assembly attaching screws.

(2) Install console. Refer to Group 23, Body, for proper procedures.

(3) Raise vehicle.

(4) Connect trunnion to torque shaft arm. Or, slide shift rod into trunnion on range lever. Be sure shift rod slides freely in trunnion.

(5) Verify that range lever is in 4L position. Then tighten trunnion lock bolt.

Fig. 4 Shift Linkage
Fig. 4 Shift Linkage

1 - RIVNUT (4)
2 - SHIFT LEVER ASSEMBLY
3 - FLOORPAN
4 - TRUNNION LOCK BOLT
5 - SELECTOR ROD AND TRUNNION
6 - SHIFT LEVER ROD
7 - TORQUE SHAFT FRAME BRACKET
8 - TORQUE SHAFT
9 - TRANSFER CASE SHIFT LEVER
10 - TORQUE SHAFT TRANSFER CASE BRACKET

(6) Lower vehicle and check transfer case shift operation.

    More about «Removal and installation»:

    Transfer case

    Shift lever

    Speedometer

    Front output shaft seal

    Jeep Cherokee Service Manual / Transmission and transfer case / NV231 transfer case / Removal and installation / Shift lever

    Jeep Cherokee Service Manual

    Categories


    © 2017-2022 Copyright www.jcherokee.com