Jeep Cherokee

 Service Manual

Speed control system » Removal and installation
Speed control servo

REMOVAL

(1) Disconnect negative battery cable at battery.

(2) Disconnect vacuum line at servo (Fig. 1).

(3) Disconnect electrical connector at servo.

(4) Disconnect servo cable at throttle body. Refer to Servo Cable Removal/Installation.

(5) Remove 2 mounting nuts holding servo cable sleeve to bracket (Fig. 2).

(6) Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip (Fig. 2) and remove clip. Note: The servo mounting bracket displayed in (Fig. 2) is a typical bracket and may/may not be applicable to this model vehicle.

Fig. 1 Speed Control Servo Location

1 - R. F. FENDER
2 - SPEED CONTROL SERVO
3 - ELECTRICAL CONNECTOR
4 - MOUNTING BRACKET
5 - VACUUM LINE

(7) Remove servo from mounting bracket. While removing, note orientation of servo to bracket.

Fig. 2 Servo Cable Clip Remove/Install-Typical

1 - SERVO MOUNTING NUTS (2)
2 - SERVO
3 - CABLE RETAINING CLIP
4 - SERVO CABLE AND SLEE

INSTALLATION

(1) Position servo to mounting bracket.

(2) Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.

(3) Insert servo mounting studs through holes in servo mounting bracket.

(4) Install servo mounting nuts and tighten to 8.5 N·m (75 in. lbs.).

(5) Connect vacuum line at servo.

(6) Connect electrical connector at servo.

(7) Connect servo cable to throttle body. Refer to Servo Cable Removal/Installation.

(8) Connect negative battery cable to battery.

(9) Before starting engine, operate accelerator pedal to check for any binding.

Speed control servo

Speed control switch

Servo cable

Vacuum reservoir