Toyota
Jeep Cherokee
 Service Manual
Speed control system » Removal and installation
Speed control switch

WARNING: BEFORE ATTEMPTING TO DIAGNOSE, REMOVE OR INSTALL ANY AIRBAG SYSTEM OR RELATED STEERING WHEEL AND STEERING COLUMN COMPONENTS YOU MUST FIRST DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE. WAIT 2 MINUTES FOR SYSTEM CAPACITOR TO DISCHARGE BEFORE FURTHER SYSTEM SERVICE. FAILURE TO DO SO COULD RESULT IN ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL

(1) Disconnect and isolate negative battery cable from battery.

(2) Remove airbag module. Refer to Group 8M, Passive Restraint Systems.

(3) From underside of steering wheel, remove speed control switch mounting screw (Fig. 3).

Fig. 3 Speed Control Switch Remove/Install
Fig. 3 Speed Control Switch Remove/Install

1 - MOUNTING SCREW
2 - SPEED CONTROL SWITCH

(4) Remove switch from steering wheel and unplug electrical connector.

INSTALLATION

(1) Plug electrical connector into switch.

(2) Position switch to steering wheel.

(3) Install switch mounting screw and tighten to 1.5 N·m (14 in. lbs.) torque.

(4) Install airbag module. Refer to Group 8M, Passive Restraint Systems.

(5) Connect negative battery cable to battery.

    More about «Removal and installation»:

    Speed control servo

    Speed control switch

    Servo cable

    Vacuum reservoir

    Jeep Cherokee Service Manual / Speed control system / Removal and installation / Speed control switch

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com