Jeep Cherokee
Service Manual
Transmission and transfer case » AW-4 automatic transmission » Removal and installation
Speed sensor

REMOVAL

(1) Disconnect sensor wire harness connector.

Fig. 49 Adapter Housing Seals

1 - 4WD ADAPTER HOUSING
2 - SEAL
3 - BUSHING
4 - OIL TUBE
5 - 2WD EXTENSION HOUSING
6 - SEAL
7 - SPEED SENSOR
8 - SPEED SENSOR

(2) Remove sensor retainer bolt and remove sensor (Fig. 50).

(3) Remove and discard speed sensor O-ring.

INSTALLATION

(1) Install new O-ring on speed sensor and install sensor in transmission case.

(2) Install sensor bracket and retainer bolt.

Tighten bolt to 7.4 N·m (65 in. lbs.) torque.

(3) Connect sensor wire harness connector.

More about «Removal and installation»:

Transmission and torque converter