Jeep Cherokee

 Owners Manual

Things to know before starting your vehicle » Remote starting system - if equipped
To Exit Remote Start Mode And Drive The Vehicle

Before the end of 15-minute cycle, push and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, prior to the end of the 15-minute cycle, push and release the START/STOP button. If the START/ STOP button is not present, insert the Key Fob into the ignition switch and turn the switch to the ON/RUN position.

NOTE:

• For vehicles not equipped with the Keyless Enter- N-Go feature, the ignition switch must be in the ON/RUN position in order to drive the vehicle
• For vehicles not equipped with the Keyless Enter- N-Go feature, the message "Remote Start Active - Insert Key and Turn To Run" will display in the EVIC/DID until you insert the key. Refer to "Electronic Vehicle Information Center (EVIC)" or "Driver Information Display" in "Understanding Your Instrument Panel" for further information.
• For vehicles equipped with the Keyless Enter-N-Go feature, the message "Remote Start Active - Push Start Button" will display in the EVIC/DID until you push the START button.

How To Use Remote Start

Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) or Driver Information Display (DID) - If Equipped

To Enter Remote Start Mode

To Exit Remote Start Mode And Drive The Vehicle

Remote Start Comfort Systems - If Equipped

General Information