Toyota
Jeep Cherokee
 Service Manual
Transmission and transfer case » AW-4 automatic transmission » Removal and installation
Transmission control module

The transmission control module is mounted under the instrument panel. On left hand drive models, it is at the driver side of the lower finish panel (Fig. 70).

On right hand drive models, it is at the passenger side of the lower finish panel (Fig. 71).

To remove the module, disconnect the wire harness, remove the mounting screws and remove the module from the finish panel. Tighten the module mounting screws securely after installation. Also be sure the wire harness is not twisted, kinked or touching any body panels.

Fig. 69 Installing Transmission Valve Body Oil Tubes
Fig. 69 Installing Transmission Valve Body Oil Tubes

Fig. 70 TCM Location (Left Hand Drive)
Fig. 70 TCM Location (Left Hand Drive)

1 - TCM
2 - LOWER FINISH PANEL

Fig. 71 TCM Location (Right Hand Drive)
Fig. 71 TCM Location (Right Hand Drive)

1 - REAR SIDE OF INSTRUMENT PANEL
2 - TCM AND HARNESS

    More about «Removal and installation»:

    Transmission and torque converter

    Torque converter

    Adapter housing seal

    Speed sensor

    Speedometer adapter

    Speed sensor rotor-speedometer drive gear

    Park/neutral position switch

    Gearshift cable

    Brake transmission shift interlock

    Transmission valve body solenoids

    Transmission valve body

    Transmission control module

    Solenoid harness adapter seal

    Manual valve shaft seal

    Accumulator pistons and springs

    Second coast brake servo

    Park rod and pawl

    Transmission throttle cable

    Oil pump seal

    Jeep Cherokee Service Manual / Transmission and transfer case / AW-4 automatic transmission / Removal and installation / Transmission control module

    Jeep Cherokee Service Manual

    Categories


    © 2017-2022 Copyright www.jcherokee.com