REMOVAL
(1) In engine compartment, disconnect cable from throttle linkage. Then compress cable mounting ears and remove cable from engine bracket (Fig. 91).
(2) Raise vehicle.
(3) Remove transmission oil pan.
(4) Disengage cable from throttle valve cam (Fig.
92).
(5) Remove cable bracket bolt and remove cable and bracket from case (Fig. 93).
(6) Remove and discard cable seal.
Fig. 90 Removing/Installing Park Pawl, Pin And Spring
1 - SPRING
2 - PIN
3 - PARK PAWL
Fig. 91 Transmission Throttle Cable Attachment
1 - THROTTLE CABLE
2 - CABLE GUIDE
3 - ACCELERATOR CABLE
4 - CABLE ENGINE BRACKET
5 - CONVERTER HOUSING
6 - THROTTLE CABLE
7 - CABLE RETAINER SCREW
8 - CABLE BRACKET
9 - DASH PANEL
10 - THROTTLE BODY
Fig. 92 Removing/Installing Transmission Throttle Cable
1 - THROTTLE CABLE
2 - CABLE BRACKET
Fig. 93 Removing/Installing Transmission Throttle Cable And Bracket
1 - THROTTLE CABLE
2 - CABLE BRACKET
INSTALLATION
(1) Lubricate and install new seal on cable.
(2) Insert cable in transmission case.
(3) Attach cable to throttle cam (Fig. 92).
(4) Install cable bracket on case and tighten attaching bolt to 10 N·m (7 ft. lbs.) torque (Fig. 93).
(5) Install pan and tighten pan bolts to 7 N·m (65 in. lbs.) torque.
(6) Install new gasket on oil pan drain plug.
Install and tighten plug to 20 N·m (15 ft. lbs.) torque.
(7) Connect cable to engine bracket and throttle linkage.
(8) Fill transmission with Mopart Dexron/Mercon IIE.
(9) Adjust the cable as described in cable adjustment procedure.