Jeep Cherokee

 Service Manual

Speed control system » Removal and installation
Vacuum reservoir

REMOVAL

The vacuum reservoir is located behind right front bumper end cap on vehicles equipped with LHD (Left Hand Drive) (Fig. 5). It is located behind left front bumper end cap on vehicles equipped with RHD (Right Hand Drive).

(1) Remove front bumper end cap. Refer to Front Bumper End Cap Removal/Installation.

(2) Remove vacuum line at reservoir (Fig. 6).

(3) Remove 2 reservoir mounting screws.

(4) Remove reservoir from bumper bar.

Fig. 5 Vacuum Reservoir Location

1 - BUMPER END CAP
2 - VACUUM RESERVOIR

INSTALLATION

(1) Position reservoir to bumper bar and install mounting screws. Tighten screws to 8 N·m (72 in.

lbs.) torque.

(2) Install vacuum line to reservoir (3) Install front bumper end cap. Refer to Front Bumper End Cap Removal/Installation.

Fig. 6 Vacuum Reservoir Removal/Installation

1 - VACUUM LINE
2 - RESERVOIR SCREWS
3 - VACUUM RESERVOIR

Speed control servo

Speed control switch

Servo cable

Vacuum reservoir