Toyota
Jeep Cherokee
 Service Manual
Engine » 2.5L engine » Removal and installation
Vibration damper

REMOVAL

(1) Disconnect negative cable from battery.

(2) Remove the serpentine drive belt and fan shroud.

(3) Remove the vibration damper retaining bolt and washer.

(4) Use Vibration Damper Removal Tool 7697 to remove the damper from the crankshaft (Fig. 61).

INSTALLATION

(1) Apply Mopar Silicone Rubber Adhesive Sealant to the keyway in the crankshaft and insert the key

Fig. 61 Vibration Damper Removal Tool 7697
Fig. 61 Vibration Damper Removal Tool 7697

1 - VIBRATION DAMPER REMOVAL TOOL
2 - WRENCH

With the key in position, align the keyway on the vibration damper hub with the crankshaft key and tap the damper onto the crankshaft.

(2) Install the vibration damper retaining bolt and washer.

(3) Tighten the damper retaining bolt to 108 N·m (80 ft. lbs.) torque.

(4) Install the serpentine drive belt and tighten to the specified tension (refer to Group 7, Cooling Systems for the proper specifications and procedures).

(5) Connect negative cable to battery.

    More about «Removal and installation»:

    Engine mounts-front

    Engine mount-rear

    Engine

    Intake manifold

    Exhaust manifold

    Cylinder head cover

    Rocker arms and push rods

    Valve spring and seal

    Cylinder head

    Cylinder head

    Hydraulic tappets

    Vibration damper

    Timing case cover oil seal

    Timing case cover

    Timing chain and sprockets

    Camshaft

    Camshaft pin replacement

    Camshaft bearings

    Crankshaft main bearings

    Oil pan

    Oil pump

    Piston and connecting rod

    Rear main oil seal

    Jeep Cherokee Service Manual / Engine / 2.5L engine / Removal and installation / Vibration damper

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com