Toyota
Jeep Cherokee
 Service Manual
Transmission and transfer case » Automatic transmission-30RH » Removal and installation
Yoke seal replacement

REMOVAL

(1) Raise vehicle.

(2) Mark propeller shaft and axle yoke for alignment reference.

(3) Disconnect and remove propeller shaft.

(4) Remove old seal with Seal Remover C-3985-B (Fig. 71) from extension housing.

INSTALLATION

(1) Place seal in position on extension housing.

(2) Drive seal into extension housing with Seal Installer C-3995-A or C-3972 (Fig. 72).

(3) Carefully guide propeller shaft slip yoke into housing and onto output shaft splines. Align marks made at removal and connect propeller shaft to rear axle pinion yoke.

Fig. 71 Removing Extension Housing Yoke Seal
Fig. 71 Removing Extension Housing Yoke Seal

1 - SPECIAL TOOL C-3985-B
2 - SEAL

Fig. 72 Installing Extension Housing Yoke Seal
Fig. 72 Installing Extension Housing Yoke Seal

1 - SPECIAL TOOL C-4171
2 - SPECIAL TOOL C-3995-A

    More about «Removal and installation»:

    Transmission

    Torque converter

    Yoke seal replacement

    Extension housing bushing

    Adapter housing

    Speedometer adapter

    Park/neutral position switch

    Gearshift cable

    Brake transmission shift interlock

    Valve body

    Output shaft rear bearing

    Governor and park gear

    Park lock

    Jeep Cherokee Service Manual / Transmission and transfer case / Automatic transmission-30RH / Removal and installation / Yoke seal replacement

    Jeep Cherokee Service Manual

    Categories


    © 2017-2024 Copyright www.jcherokee.com