Jeep Cherokee (XJ): Disassembly and assembly. Specifications

Jeep Cherokee (XJ) 1984 - 2001 Service Manual > Brakes > Antilock brakes > Disassembly and assembly. Specifications

Disassembly and assembly

HYDRAULIC CONTROL UNIT/CONTROLLER ANTILOCK BRAKE

DISASSEMBLY

(1) Remove pump motor connector from the CAB.

(2) Remove CAB mounting screws from the HCU (Fig. 13).

(3) Remove CAB from the HCU.

Fig. 13 CAB Mounting Screws
Fig. 13 CAB Mounting Screws

1 - MOUNTING SCREWS
2 - CAB

ASSEMBLY

(1) Install the CAB onto the HCU.

(2) Install the CAB mounting screws and tighten to 1.8 N·m (16 in. lbs.).

(3) Install pump motor connector to the CAB.

Specifications

T0RQUE CHART

DESCRIPTION TORQUE

G-Sensor

Sensor Bolt . . . . . . . . . . . . . . 3 N·m (27.5 in. lbs.)
Bracket Bolt . . . . . . . . . . . . . 2.7 N·m (24 in. lbs.)
Hydraulic Control Unit/Controller Antilock

Brakes

Mounting Nuts . . . . . . . . . 11.5 N·m (102 in. lbs.)
Brake Lines . . . . . . . . . . . . . 19 N·m (170 in. lbs.)

Controller Antilock Brakes

Mounting Screws . . . . . . . . . 1.8 N·m (16 in. lbs.)

Wheel Speed Sensors

Front Mounting Bolt . . . . . . 4.7 N·m (42 in. lbs.)
Rear Mounting Bolt . . . . . . . 13 N·m (115 in. lbs.)

    Previous pageDiagnosis and testing. Service procedures. Removal and installation

    Diagnosis and testing ANTILOCK BRAKES The ABS brake system performs several self-tests every time the ignition switch is turned on and the vehicle is driven. The CAB monitors the systems input and ...

    Next pageClutch

    ...

    Other materials:

    181 FBI pinion gear depth
    GENERAL INFORMATION Ring and pinion gears are supplied as matched sets only. The identifying numbers for the ring and pinion gear are etched into the face of each gear (Fig. 71). A plus (+) number, minus (-) number or zero (0) is etched into the face of the pinion gear. This number is the am ...