Jeep Cherokee (KL): Rear window features

Rear Window Wiper/Washer

The rear wiper/washer controls are located on the windshield wiper/washer lever on the right side of the steering column. The rear wiper/washer is operated by rotating a switch, located at the middle of the lever.

Rear Wiper/Washer Control
Rear Wiper/Washer Control

Rotate the center portion of the lever upward to the first detent for intermittent operation and to the second detent for continuous rear wiper operation.

To use the washer, push the lever forward and hold while spray is desired. If the lever is pushed while in the intermittent setting, the wiper will turn on and operate for several wipe cycles after the end of the lever is released, and then resume the intermittent interval previously selected.

If the lever is pushed while the wiper is in the off position, the wiper will operate for several wipe cycles, then turn off.

NOTE: As a protective measure, the pump will stop if the switch is held for more than 20 seconds. Once the lever is released the pump will resume normal operation.

If the rear wiper is operating when the ignition is turned OFF, the wiper will automatically return to the "park" position.

Rear Window Defroster

The rear window defroster button is located on the switch bank by the manual climate controls.

Push this button to turn on the rear window defroster and the heated outside mirrors. An indicator in the button will illuminate when the rear window defroster is on. The rear window defroster automatically turns off after approximately 10 minutes. For an additional five minutes of operation, push the button a second time.

NOTE:

  • The Windshield Wiper De-Icer (if equipped) shall be activated automatically when the Rear Defrost is turned on and when the ambient temperature is below 33 degrees F (0.6 C).
  • To prevent excessive battery drain, use the rear window defroster only when the engine is operating.

CAUTION!

Failure to follow these cautions can cause damage to the heating elements:

  • Use care when washing the inside of the rear window. Do not use abrasive window cleaners on the interior surface of the window. Use a soft cloth and a mild washing solution, wiping parallel to the heating elements. Labels can be peeled off after soaking with warm water.
  • Do not use scrapers, sharp instruments, or abrasive window cleaners on the interior surface of the window.
  • Keep all objects a safe distance from the window

    Previous pageCargo area features

    Cargo Load Floor The cargo load floor system has a load capacity of 400 lbs (181 kg). To provide additional storage area, each rear seat can be folded flat. This allows for extended cargo space a ...

    Next pageRoof luggage rack

    The load carried on the roof, when equipped with a luggage rack, must not exceed 150 lbs (68 kg), and it should be uniformly distributed over the cargo area. Crossbars should always be used whene ...

    Other materials:

    Disassembly and assembly
    NV231 TRANSFER CASE DISASSEMBLY Position transfer case on shallow drain pan. Remove drain plug and drain lubricant remaining in case. REAR RETAINER AND OIL PUMP REMOVAL (1) Remove the speedometer adapter. (2) Spread band clamp which holds output shaft boot to slinger with a suitable awl, ...