Jeep Cherokee (XJ): Removal and installation
- Engine mounts-front. Engine mount-rear. Engine assembly
- Intake and exhaust manifold
- Exhaust manifold-4.0L engine. Cylinder head cover. Rocker arms and push rods
- Valve springs and oil seals. Cylinder head. Valves and valve springs
- Hydraulic tappets. Vibration damper. Timing case cover
- Timing chain and sprockets. Camshaft. Camshaft bearings
- Crankshaft main bearings
- Oil pan
- Pistons and connecting rods
- Crankshaft oil seals-rear. Oil pump. Timing case cover oil seal
Service engine assembly (short block). Hydrostatic lock. Engine oil service
Service engine assembly (short
block)
A service replacement engine assembly (short
block) may be installed whenever the original cylinder
block is defective or damaged beyond repair. It
consists o ...
Engine mounts-front. Engine mount-rear. Engine assembly
Engine mounts-front
The front mounts support the engine at each side.
These supports are made of resilient rubber.
REMOVAL
(1) Disconnect negative cable from battery.
(2) Raise the vehicle.
...
Other materials:
Exhaust manifold. Cylinder head cover. Rocker arms and push rods
Exhaust manifold
REMOVAL
(1) Disconnect the battery negative cable.
(2) Raise the vehicle.
(3) Disconnect the exhaust pipe from the engine
exhaust manifold.
(4) Lower the vehicle.
(5) Remove intake manifold (refer to procedure in
this section)
(6) Remove fasteners 2 through 5 and rem ...