Jeep Cherokee (XJ): Removal and installation
Jeep Cherokee (XJ) 1984 - 2001 Service Manual > Transmission and transfer case > AW-4 automatic transmission > Removal and installation
- Transmission and torque converter
- Torque converter. Adapter housing seal. Speed sensor
- Speedometer adapter. Speed sensor rotor-speedometer drive gear. Park/neutral position switch
- Gearshift cable. Brake transmission shift interlock. Transmission valve body solenoids
- Transmission valve body. Transmission control module. Solenoid harness adapter seal
- Manual valve shaft seal. Accumulator pistons and springs. Second coast brake servo
- Park rod and pawl. Transmission throttle cable. Oil pump seal
Checking fluid level
(1) Be sure transmission fluid is at normal operating
temperature. Normal operating temperature is
reached after approximately 15 miles (25 km) of
operation.
(2) Position ve ...
Transmission and torque converter
REMOVAL
(1) Raise vehicle.
(2) Drain transmission fluid and reinstall oil pan
drain plug.
(3) On models with 2-piece fill tube, remove upper
half of tube (Fig. 45).
Fig. 45 Transmission ...
Other materials:
Service engine assembly (short
block). Hydrostatic lock. Engine oil service
Service engine assembly (short
block)
A service replacement engine assembly (short
block) may be installed whenever the original cylinder
block is defective or damaged beyond repair. It
consists of the cylinder block, crankshaft, piston and
rod assemblies. If needed, the camshaft must be procur ...