Jeep Cherokee (KL): Shift lever override

Jeep Cherokee (KL) 2014 - 2023 Owners Manual > What to do in emergencies > Shift lever override

If a malfunction occurs and the shift lever cannot be moved out of the PARK position, you can use the following procedure to temporarily move the shift lever: 1. Turn the engine OFF.

2. Apply the parking brake.

3. Using a screwdriver or similar tool, carefully separate the shifter bezel and boot assembly from the center console.

4. Press and maintain firm pressure on the brake pedal.

5. Insert a small screwdriver or similar tool down into the shift lever override access hole (at the right front corner of the shift lever assembly), and push and hold the override release lever down.

6. Move the shift lever to the NEUTRAL position.

7. The vehicle may then be started in NEUTRAL.

8. Reinstall the shift lever boot.

    Previous pageRecovery strap

    Your vehicle may be included with a recovery strap. Recovery straps do not act like traditional tow straps, chains, or winch cables. WARNING! Recovery straps should only be used in emergencies t ...

    Next pageTowing a disabled vehicle

    This section describes procedures for towing a disabled vehicle using a commercial towing service. If the transmission and drivetrain are operable, disabled 4x4 vehicles may also be towed as descri ...

    Other materials:

    Disassembly and assembly
    Housing end plug DISASSEMBLY (1) Unseat and remove retaining ring from groove with a punch through the hole in the end of the housing (Fig. 2). Fig. 2 End Plug Retaining Ring 1 - RETAINING RING (2) Slowly rotate stub shaft with 12 point socket COUNTER-CLOCKWISE to force the end plug out ...