Jeep Cherokee (XJ): Shifter/ignition interlock

Jeep Cherokee (XJ) 1984 - 2001 Service Manual > Ignition system > Removal and installation > Shifter/ignition interlock

REMOVAL/INSTALLATION

On models equipped with an automatic transmission, a cable connects the ignition switch with the floor shift lever. The shifter will be locked in the PARK position when the ignition key is in the LOCK or ACCESSORY positions. The cable can be adjusted or replaced. Refer to Group 21, Transmissions for procedures. The ignition interlock device within the steering column is not serviceable. If service is necessary, the steering column must be replaced. Refer to Group 19, Steering for procedures.

    Previous pageIgnition switch and key cylinder

    The ignition key must be in the key cylinder for cylinder removal. The key cylinder must be removed first before removing ignition switch. KEY CYLINDER REMOVAL (1) Disconnect negative battery cabl ...

    Next pageSpecifications

    Ignition timing Ignition timing is not adjustable on any engine. Engine firing order-2.5L 4-cylinder engine Engine firing order-4.0L 6-cylinder engine Spark plugs Spark plug cable resi ...

    Other materials:

    Removal and installation
    Horn relay REMOVAL (1) Disconnect and isolate the battery negative cable. (2) Remove the fuse access panel by unsnapping it from the right cowl side inner trim panel (Fig. 3). (3) Remove the push nut that secures the right cowl side inner trim panel to the junction block stud. (4) Remov ...