Jeep Cherokee (KL): Tire Pressure. Tire Inflation Pressures. Tire Pressures For High Speed Operation

Jeep Cherokee (KL) 2014 - 2023 Owners Manual > Starting and operating > Tires - general information > Tire Pressure. Tire Inflation Pressures. Tire Pressures For High Speed Operation

Tire Pressure

Proper tire inflation pressure is essential to the safe and satisfactory operation of your vehicle. Four primary areas are affected by improper tire pressure:

  • Safety and Vehicle Stability
  • Economy
  • Tread Wear
  • Ride Comfort

Safety

WARNING!

  • Improperly inflated tires are dangerous and can cause collisions.
  • Underinflation increases tire flexing and can result in overheating and tire failure.
  • Overinflation reduces a tire's ability to cushion shock. Objects on the road and chuckholes can cause damage that result in tire failure.
  • Overinflated or underinflated tires can affect vehicle handling and can fail suddenly, resulting in loss of vehicle control.
  • Unequal tire pressures can cause steering problems.

    You could lose control of your vehicle.

  • Unequal tire pressures from one side of the vehicle to the other can cause the vehicle to drift to the right or left
  • Always drive with each tire inflated to the recommended cold tire inflation pressure.

Both under-inflation and over-inflation affect the stability of the vehicle and can produce a feeling of sluggish response or over responsiveness in the steering.

NOTE:

  • Unequal tire pressures from side to side may cause erratic and unpredictable steering response.
  • Unequal tire pressure from side to side may cause the vehicle to drift left or right.

Fuel Economy

Underinflated tires will increase tire rolling resistance resulting in higher fuel consumption.

Tread Wear

Improper cold tire inflation pressures can cause abnormal wear patterns and reduced tread life, resulting in the need for earlier tire replacement.

Ride Comfort And Vehicle Stability

Proper tire inflation contributes to a comfortable ride.

Over-inflation produces a jarring and uncomfortable ride.

Tire Inflation Pressures

The proper cold tire inflation pressure is listed on the driver's side B-Pillar or rear edge of the driver's side door.

At least once a month:

  • Check and adjust tire pressure with a good quality pocket-type pressure gauge. Do not make a visual judgement when determining proper inflation. Tires may look properly inflated even when they are underinflated.
  • Inspect tires for signs of tire wear or visible damage.

CAUTION!

After inspecting or adjusting the tire pressure, always reinstall the valve stem cap. This will prevent moisture and dirt from entering the valve stem, which could damage the valve stem.

Inflation pressures specified on the placard are always "cold tire inflation pressure". Cold tire inflation pressure is defined as the tire pressure after the vehicle has not been driven for at least three hours, or driven less than 1 mile (1.6 km) after sitting for a minimum of three hours.

The cold tire inflation pressure must not exceed the maximum inflation pressure molded into the tire sidewall.

Check tire pressures more often if subject to a wide range of outdoor temperatures, as tire pressures vary with temperature changes.

Tire pressures change by approximately 1 psi (7 kPa) per 12F (7C) of air temperature change. Keep this in mind when checking tire pressure inside a garage, especially in the Winter.

Example: If garage temperature = 68F (20C) and the outside temperature = 32F (0C) then the cold tire inflation pressure should be increased by 3 psi (21 kPa), which equals 1 psi (7 kPa) for every 12F (7C) for this outside temperature condition.

Tire pressure may increase from 2 to 6 psi (13 to 40 kPa) during operation. DO NOT reduce this normal pressure build up or your tire pressure will be too low.

Tire Pressures For High Speed Operation

The manufacturer advocates driving at safe speeds and within posted speed limits. Where speed limits or conditions are such that the vehicle can be driven at high speeds, maintaining correct tire inflation pressure is very important. Increased tire pressure and reduced vehicle loading may be required for high-speed vehicle operation.

Refer to your authorized tire dealer or original equipment vehicle dealer for recommended safe operating speeds, loading and cold tire inflation pressures.

WARNING!

High speed driving with your vehicle under maximum load is dangerous. The added strain on your tires could cause them to fail. You could have a serious collision. Do not drive a vehicle loaded to the maximum capacity at continuous speeds above 75 mph (120 km/h).

    Next pageRadial Ply Tires. Tire Types. Run Flat Tires

    Radial Ply Tires WARNING! Combining radial ply tires with other types of tires on your vehicle will cause your vehicle to handle poorly. The instability could cause a collision. Always use radial ...

    Other materials:

    Diagnosis and testing
    General information Axle bearing problem conditions are usually caused by:  Insufficient or incorrect lubricant.  Foreign matter/water contamination.  Incorrect bearing preload torque adjustment. Fig. 4 Trac-lokY Limited Slip Differential Operation 1 - CASE 2 - RING ...