Jeep Cherokee (KL): Tire rotation recommendations

The tires on the front and rear of your vehicle operate at different loads and perform different steering, handling, and braking functions. For these reasons, they wear at unequal rates.

These effects can be reduced by timely rotation of tires.

The benefits of rotation are especially worthwhile with aggressive tread designs such as those on On/Off Road type tires. Rotation will increase tread life, help to maintain mud, snow, and wet traction levels, and contribute to a smooth, quiet ride.

Refer to the "Maintenance Schedule" for the proper maintenance intervals. The reasons for any rapid or unusual wear should be corrected prior to rotation being performed.

The suggested Front Wheel Drive (FWD) rotation method is the "forward cross" shown in the following diagram. This rotation pattern does not apply to some directional tires that must not be reversed.

Front Wheel Drive (FWD) Tire Rotation
Front Wheel Drive (FWD) Tire Rotation

The suggested Four Wheel Drive (4WD) Tire rotation method is the "rearward cross" shown in the following diagram.

Four Wheel Drive (4WD) Tire Rotation
Four Wheel Drive (4WD) Tire Rotation

CAUTION!

Proper operation of four-wheel drive vehicles depends on tires of equal size, type and circumference on each wheel. Any difference in tire size can cause damage to the power transfer unit. Tire rotation schedule should be followed to balance tire wear.

    Previous pageTire chains (traction devices)

    Use of traction devices require sufficient tire-to-body clearance. Follow these recommendations to guard against damage. Traction device must be of proper size for the tire, as recommended by ...

    Next pageTire pressure monitor system (tpms)

    The Tire Pressure Monitor System (TPMS) will warn the driver of a low tire pressure based on the vehicle recommended cold placard pressure. The tire pressure will vary with temperature by approxi ...

    Other materials:

    Front door lock cylinder. Lock cylinders. Front door latch
    Front door lock cylinder REMOVAL (1) Remove the door trim panel. (2) Peel back waterdam to access lock cylinder. (3) Disconnect the door latch-to-lock cylinder rod at the door latch (Fig. 29). (4) Remove the lock cylinder retainer clip. (5) Remove the lock cylinder. (6) If applicabl ...