Jeep Cherokee (KL): To open and close the hood

Two latches must be released to open the hood.

1. Pull the hood release lever located under the drivers side of the instrument panel.

Hood Release
Hood Release

2. Move to the outside of the vehicle and pull the safety latch release lever forward (toward you). The safety latch release lever is located behind the front edge of the hood, slightly off-center to the right.

Hood Safety Latch Release Lever Location
Hood Safety Latch Release Lever Location

CAUTION!

To prevent possible damage, do not slam the hood to close it. Lower the hood until it is open approximately 6 inches (15 cm), and then drop it. This should secure both latches. Never drive your vehicle unless the hood is fully closed, with both latches engaged.

WARNING!

Be sure the hood is fully latched before driving your vehicle. If the hood is not fully latched, it could open when the vehicle is in motion and block your vision.

Failure to follow this warning could result in serious injury or death.

    Previous pageDriver memory seat

    This feature allows the driver to store up to two different memory profiles, for easy recall through a memory switch. Each memory profile contains desired position settings for the driver seat and ...

    Next pageLights

    ...

    Other materials:

    Cleaning and inspection
    Caliper CLEANING Clean the caliper components with clean brake fluid or brake clean only. Wipe the caliper and piston dry with lint free towels or use low pressure compressed air. CAUTION: Do not use gasoline, kerosene, thinner, or similar solvents. These products may leave a residue that cou ...